Search results

Yes, please!

I bought a shorter (3" length) tri clamp thermowell off eBay. I don't see a similar item listed anymore, but some searching might turn up another option. It's still long enough to fit the dial thermometer shaft, since there's still several inches outside the kettle for the tri clamp fitting. I'm...

I have 4 or 5 cases (12 per case) of amber 22-oz bomber bottles. 4 of the cases were purchased new, and have boxes to go in. The rest were reused from store bought beer, some delabeled, some not. All are clean. I've switched over to kegging, so no longer need the bottles. I'm in the Rochester...

Me too!

So will either the "Flashed" or "Flashable" versions have the header installed on the pins needed for programming, or is that part still DIY? Thanks!

One, please!

The John Guest fittings work nicely for the keg side and for a faucet/shank setup, but is there an easy way to connect in a tower setup?

One, please!

I have some terrible news for you: You built it all upside-down! All the grain's going to fall out that way...

Promo code, please!

Read the entire thread. Left disappointed that not ONE person said "Not Constantinople?"

One, please!

ThermoWorks guide on creating a proper ice bath for calibration: http://www.thermoworks.com/learning/thermapen101_creating_an_icebath.html (Not that the above posts were incorrect, just adding the "from the horse's mouth" info.)

Thanks, all. The input is appreciated. First all-grain batch planned for Sunday, so fingers crosses. -mike

Just tested out my new MM2 for the first time with a few pounds of the cheapest grain they had at the LHBS. The gap seems to be about .032 or so. It took a little fussing to get the idler roller to spin freely, and I had to run the drill a bit faster than I thought to get things moving. Opinions...

Stuff

Edited: Nevermind. I was looking at the picture wrong.