My stainless steel counterflow chiller comes with a plate and two screw holes, I drilled and tapped two corresponding holes in my Brutus frame and bolted it down. As far as making mounts for my Chugger pumps, all I did was trace the "foot" and hole locations of the pump onto cardboard and used it to cut aluminum plate to match. I put 2 extra holes in it to bolt onto my frame and again, drilled and tapped the threads on the frame and mounted it. Painted the plate to match the color of my Brutus.
If I understand what these clamps do, I think I could use 2 clamps to mount a horizontal strut bar between two legs of the table and mount everything to the strut.
Check out this thread. There are a lot of pictures on here showing how strut can be used. My stand is on here as well.
https://www.homebrewtalk.com/showthread.php?t=363128&highlight=strut
https://www.homebrewtalk.com/showpost.php?p=5111820&postcount=476
You can see the my pump is mounted to the strut, but you can't see the clamp because I have a heat shield over it.
I didn't have a chiller when I took there, but it is mounted to the strut as well.
Enter your email address to join: