I replaced the thermostat in an old upright freezer and installed a TS2 controller. It seemed to work just fine for the first four hours or so. Then the it simply 'shut off'. What I mean by that is that the freezer had power, but the controller did not. I checked all of the wiring and I have continuity in both power supply lines from the wall to the inputs of the controller. While standing behind the freezer looking at the schematic trying to figure out what I might have missed, (fuze, etc) the controller magically turned back on and the compressor started cooling again!?!
I am wondering if I have it programmed wrong or if there is something wrong with the temp controller. Here is what I set:
SP: 50
r0: 1
r1: 48
r2: 52
d0: Co
d2: 0
d8: 0
All other values were left at default values.
Keith
I am wondering if I have it programmed wrong or if there is something wrong with the temp controller. Here is what I set:
SP: 50
r0: 1
r1: 48
r2: 52
d0: Co
d2: 0
d8: 0
All other values were left at default values.
Keith