Wow, that is just crazy!
I'm fascinated with the background graphics of your control panel layout. If you don't mind me asking what program did you use to design your control panel layout (kettles,sight glass,valves,chillers etc..) with?
Best of luck with the initial launch!!!
Brewed a few batches of beer this weekend found some issues and bugs nothing that can't be fixed. Re-tweaked the fermentation interface. Ordered the parts today for automating the fermenter transfer and auto spunding.
What boggles my mind is how clean and simple your panel layout is, yet at the same time demonstrates the endless and complex possibilities BruControl has to offer. Well done Die_Beerery you have definitely taken this to the next level.
[...]Well done Die_Beerery you have definitely taken this to the next level.
How are you currently doing hop additions? if the system is purged and sealed, how are you adding hops at desired time-points?
Ah that makes sense. So you open one of the ports and toss some in once your at 212 I assume. Cool. Do you re-purge the kettle with n2 during chilling?It's not sealed during boiling.
Another question...are your HIM Hart loops each 2 analog out or 3 analog out?
View attachment 598031 MM Mass Flow DS100HView attachment 598032Better condition then expected one was a bit dirty but should clean up nice. View attachment 598034Bigger then I expected.
View attachment 598042
10" welded tri clamp fittings ordered from china for the 3 kettles (x3). drilling and welding several 1.5 inch tri-clover fittings into each.View attachment 598037pressure sensor spec'd from china. 0-3psi, 3x burst rating, 0.2% FS, 150C rated, X6. For Hydrostatic pressure volume determination of the pressurized vessels. View attachment 598038HIMS for the FRT 9712s arrived View attachment 5980393750 boil coil for the BK. View attachment 5980401 of 2 RTF 9712s due to arrive. View attachment 5980412 x 5500 W ripples for the HLT.
Buch of crap still due to arrive like bunch of Broadley J DO sensors and Ph probes, Rosemount 1056 boxes, MT DO boxes, Hoffman Enclosure, relay boards, flow sensors, etc. Still need to get valves ordered from china also.
Hoping to get a good amount of welding done over thanksgiving on the kettles.
This.Wow. Might want to document this in a unique thread. Looking forward to the welding!
This.
What the hell are you up to?
I ordered them to specification in china using alibaba. Specifically, Company: Shaanxi Qijia Automation Technology Co.,Ltd.Where did you get the pressure sensors?
Enter your email address to join: