MapleGroveAleworks
Well-Known Member
Hey all. I have a Monster Mill 2.0 2 roller mill I've had for about 3 years.
Every now and then the set screws (the ones you hand tighten) will pop loose while milling, the rollers lose their gap, and I'll have to dump all the grain out - reset the mill gaps and start over.
My method is to mist my grain with a little bit of water from a spray bottle and mix it up thoroughly, then mill at about .30 to 34 or so. Nothing too crazy. I use a Makita corded 1/2" drill to mill - very strong drill.
I've never oiled it or anything - no idea how. Any ideas why it keeps popping loose?
Thanks
Every now and then the set screws (the ones you hand tighten) will pop loose while milling, the rollers lose their gap, and I'll have to dump all the grain out - reset the mill gaps and start over.
My method is to mist my grain with a little bit of water from a spray bottle and mix it up thoroughly, then mill at about .30 to 34 or so. Nothing too crazy. I use a Makita corded 1/2" drill to mill - very strong drill.
I've never oiled it or anything - no idea how. Any ideas why it keeps popping loose?
Thanks