milldoggy
Well-Known Member
All,
I am going to install a built in IC in my BK and was wondering if copper would be ok? Stainless will probably be easier to clean, but copper conducts heat much faster. Is there another reason to go SS? Boiling 60/90 minutes ok for cooper? I was thinking about using 50', but would 30 work, that way I can use 20 for my herms coil? I was planning on using 1/2" OD either way, unless 3/8" 25' would work for the herms coil(i already have this and would save me from buying another coil).
My end result will be a Ditches setup. I am thinking I should just go with 50' stainless in each to be safe. I was also thinking about installing using a flare fitting, instead of compression, any issues here?
Thanks!
I am going to install a built in IC in my BK and was wondering if copper would be ok? Stainless will probably be easier to clean, but copper conducts heat much faster. Is there another reason to go SS? Boiling 60/90 minutes ok for cooper? I was thinking about using 50', but would 30 work, that way I can use 20 for my herms coil? I was planning on using 1/2" OD either way, unless 3/8" 25' would work for the herms coil(i already have this and would save me from buying another coil).
My end result will be a Ditches setup. I am thinking I should just go with 50' stainless in each to be safe. I was also thinking about installing using a flare fitting, instead of compression, any issues here?
Thanks!