The snake connectors are cheap plastic and leak. I have two of them I got as a sample and they are honestly only good unless the sanke fitting is connected the entire time.
I have no floor drain and keep a mop and bucket on hand. I am only doing 12 gallon batches, but I made a drip tray out of aluminum sheeting that can catch boilover or general spillage. It's very effective.
Hey all, I'm having problems with my onewire sensors. After acting wacky when I turned my heater on they now no longer show up at all. Not even under devices. I tried a new sensor with no luck. Could something have fried out on me? The resistor seems fine. Checked that with the meter. I swapped...
Question. I am having an issue with the Onewire sensors when I turn my heating element on. I use a thermal-well now in a keggle. I think since the element uses the kettle as a ground, it may be causing interference with the sensors. When I turn the element on, it shows 32F on both my...
Hey everyone! Does anyone use the cheap relay boards with a Terragady? I would need a LOW output from the GPIO instead of 12v, and I am trying to find a solution here.
This specific relay board is designed for 12v but I forgot it needed the LOW input to trigger the relay vs the HIGH input...
Hey man I am having the same exact problem! I did a clean install of raspbian bc I thought it may be brewpi at fault. I did update the file as you mentioned, but it didn't solve the issue. Is there something else you might have changed at the same time that solved the issue? I'm at a loss!
I just kegged my third batch of this bad boy. I get a heavy hop flavor from the dry hop and I'm surprised it is missing for you! Did you dry hop in a bag or tea screen? I dry hop right into the wort.
Can't wait to drink this bad buy in a week or two!