Search results

The snake connectors are cheap plastic and leak. I have two of them I got as a sample and they are honestly only good unless the sanke fitting is connected the entire time.

BrewPi or CraftBeerPi

I have no floor drain and keep a mop and bucket on hand. I am only doing 12 gallon batches, but I made a drip tray out of aluminum sheeting that can catch boilover or general spillage. It's very effective.

Well I thought something weird like a short on the pcb may have occurred so I scraped around the pi outs and that seemed to do the trick. Weird...

Hey all, I'm having problems with my onewire sensors. After acting wacky when I turned my heater on they now no longer show up at all. Not even under devices. I tried a new sensor with no luck. Could something have fried out on me? The resistor seems fine. Checked that with the meter. I swapped...

Question. I am having an issue with the Onewire sensors when I turn my heating element on. I use a thermal-well now in a keggle. I think since the element uses the kettle as a ground, it may be causing interference with the sensors. When I turn the element on, it shows 32F on both my...

Hey everyone! Does anyone use the cheap relay boards with a Terragady? I would need a LOW output from the GPIO instead of 12v, and I am trying to find a solution here. This specific relay board is designed for 12v but I forgot it needed the LOW input to trigger the relay vs the HIGH input...

Well it occurred to me that perhaps my wires on the onewire were not as I assumed... green is data and yellow was ground lol. Working now!

One thing I noticed different from yours is a .55v reading from the one wire data ports. Should it be 5v?

Hey man I am having the same exact problem! I did a clean install of raspbian bc I thought it may be brewpi at fault. I did update the file as you mentioned, but it didn't solve the issue. Is there something else you might have changed at the same time that solved the issue? I'm at a loss!

i would highly suggest not swapping it out. The midnight wheat gives a great roasty flavor you will miss with chocolate.

Just do it and wait a extra day. It won't hurt!

I just mash at 150... I will have to try increasing the temp next time, but I doubt it makes that great of a difference!

I just kegged my third batch of this bad boy. I get a heavy hop flavor from the dry hop and I'm surprised it is missing for you! Did you dry hop in a bag or tea screen? I dry hop right into the wort. Can't wait to drink this bad buy in a week or two!

Heading out there for an event later this month - Any suggestions in your trials of new spots?

Are there links for the recipes? Specifically looking for the nut peanut butter porter to try my hand out! Sounds like an amazing experience and impressive pull off! Nice work!

Are there links for the recipes? Specifically looking for the nut peanut butter porter to try my hand out! Sounds like an amazing experience and impressive pull off! Nice work!

I went to Toronto in November and was very underwhelmed by the selection even in the store. Brews are super expensive in Canada are well ($12 for a 6 pack of standard beer selection)! I hope someone has a good suggestion for you!

Got this back on tap for the third time brewing it - It is my house brew from now until I can potentially find something better (Will be a while) :)

I've decided to make this brew my house IPA. Will forever now have it on tap (unless it runs out before I can replenish, which will probably be the case!)