Thanks!
Now that I have lived with it for a couple weeks I've noticed that it builds some pockets of CO2 in the beer line so the first pull of the day sputters a bit. It leaves about 1/2 - 1 inch of foam on the top of the first beer but every one after that is fine.
Is that common?
I...
Trunk line coming through into the basement and into the fridge:
All bundled up and ready to go! A bucket with holes drilled in the lid is used in the freezer with the pond pump in it. I'm currently using salt water which is working perfect but I might switch to glycol eventually...
So I just bought my first house this past summer. It was a bit of a fixer-upper but I couldn't be more excited about it!
Obviously I had my priorities straight because one of the first things I bought for it was a bunch of new kegerator parts and a fridge off craigslist lol. The bar build...
I figure I'll update this so that if anyone else is searching and winds up here the thread will be resolved.
I took a 2" hole saw to the side of the fridge towards the front and had zero issues with hitting any refrigerant lines. I did a 1" hole just below it for the air lines as well and had...
I was planning on removing the taps from the tower and feeding the tubing up the tower and through the tap hole. Then heating and connecting the tubing to the tap shank and crimp it on. Then re-install the hooked up tap into the tower.
I was just curious how to connect the Bev-seal to that...
I'm about to hook up my beer lines to the kegerator I'm building and I have a quick question.
I am going to be running Accuflex Bev-seal from my kegerator up to the tower. I have read a bunch of threads on the best way to heat and stretch the tubing over the barbed fittings for the keg side...
I'll probably do that just for comfort reasons.
Also, I just realized there is a post about a fridge just like mine a few posts down in DIY in regards to drilling holes in the side! Oops lol, not sure how I missed that before posting, considering I searched the forum first. I must be getting...
I just finally got all the parts for my kegerator!
I am going to essentially be doing what runningweird did with his setup in this post:
https://www.homebrewtalk.com/f35/long-draw-salt-water-chilled-beer-tower-271578/
Except mine will only be two taps instead of six. I just got the...