Ran my system last night and everything went really well, but I overshot my strike temp by roughly seven degrees. I've got a Thermowell run through the side of my kettle, and it's at the same height as my element and between the drain and the element. Photo attached.
I've got a four inch probe screwed into that Thermowell. I don't have any grease in there. I'm not circulating while heating the strike water. And finally I'm running the DSPR320 ezboil.
Anyone have experience like this with that controller? Could it be caused by an air gap between the Thermowell and the probe?
I've got a four inch probe screwed into that Thermowell. I don't have any grease in there. I'm not circulating while heating the strike water. And finally I'm running the DSPR320 ezboil.
Anyone have experience like this with that controller? Could it be caused by an air gap between the Thermowell and the probe?