haeffnkr
Well-Known Member
Tell my why this wont work please.
If I put a 16" pot, the inside of the boil coil diameter, and then fill the gap with water for heat transfer only. Then recirculate the wort and could even be pumped back through a stainless coil on the outside of the MT in the heated water, like a HERMS.
I would think this ramp up temps fast and keep very consistent temps.
I already have the 25 gallon pot as pictured that I dont use. I just need to find about a 20 gallon MT pot with a 16" diameter then put a drain on it through the outside of the 25 gallon pot so I can pump the wort back into the MT pot.
I already have a 30 amp controller and stainless coil.
It is either this or I will build a RIMS like augiedoggy with a cartridge heater.
I want to have some sort of full volume recirculated mash setup.
With this setup, no issues with boiling wort, gentle ramps and I have most of it already.
Thoughts?
If I put a 16" pot, the inside of the boil coil diameter, and then fill the gap with water for heat transfer only. Then recirculate the wort and could even be pumped back through a stainless coil on the outside of the MT in the heated water, like a HERMS.
I would think this ramp up temps fast and keep very consistent temps.
I already have the 25 gallon pot as pictured that I dont use. I just need to find about a 20 gallon MT pot with a 16" diameter then put a drain on it through the outside of the 25 gallon pot so I can pump the wort back into the MT pot.
I already have a 30 amp controller and stainless coil.
It is either this or I will build a RIMS like augiedoggy with a cartridge heater.
I want to have some sort of full volume recirculated mash setup.
With this setup, no issues with boiling wort, gentle ramps and I have most of it already.
Thoughts?
Last edited: