Hi All,
Just got my complete 3v system in over Black Friday. I had researched enough of the system to expect problems, but did not expect to be restricted in the controller menus.
I am hoping someone has had this same issue and has found a way to resolve it.
My controller is obviously set to on/off operation and not PID. There is obviously a 1 degree hysteresis. When setting my mash tun to 150 degrees and recirculating through my rims, the system powers on at 149 degrees. It quickly hits 150, powers off, but continues to overshoot up to 153 degrees. The element is powering on at 100%, as it does in on/off mode.
This is while running a water test only. Pump is set to max flow as suggested by Ssbrewtech.
I have found a manual online for the omron e5cc controller, but accessing the menu doesn’t work like instructions say. Supposed to only push the far left button for 3 seconds to access the menu. That does nothing. Pressing the 2 far left buttons together accesses a menu, but the options in that menu are not what I’m looking for.
I need to find the menu to access the on/off -PID setting, as well as auto tune after selecting PID.
Any help would be greatly appreciated. I’ve submitted a support ticket to Ss asking the same, but I’d like to brew tomorrow. It expecting an answer from them till Monday-Wednesday.
Just got my complete 3v system in over Black Friday. I had researched enough of the system to expect problems, but did not expect to be restricted in the controller menus.
I am hoping someone has had this same issue and has found a way to resolve it.
My controller is obviously set to on/off operation and not PID. There is obviously a 1 degree hysteresis. When setting my mash tun to 150 degrees and recirculating through my rims, the system powers on at 149 degrees. It quickly hits 150, powers off, but continues to overshoot up to 153 degrees. The element is powering on at 100%, as it does in on/off mode.
This is while running a water test only. Pump is set to max flow as suggested by Ssbrewtech.
I have found a manual online for the omron e5cc controller, but accessing the menu doesn’t work like instructions say. Supposed to only push the far left button for 3 seconds to access the menu. That does nothing. Pressing the 2 far left buttons together accesses a menu, but the options in that menu are not what I’m looking for.
I need to find the menu to access the on/off -PID setting, as well as auto tune after selecting PID.
Any help would be greatly appreciated. I’ve submitted a support ticket to Ss asking the same, but I’d like to brew tomorrow. It expecting an answer from them till Monday-Wednesday.