jonp9576
Well-Known Member
i guess it was going well. it was frustrating coiling the copper, but i hope it does a good job.
i used a piece of square aluminum for the support and then ran 2 different sized coils through it. i havent decided yet if i am just going to connect the two at the bottom or if i am going to extend them and make it 2 completely separate coils giving each a cold water feed or just make it all one big coil.
ideas?
if i make it all one piece should i have the cold go to the inner coil first or the outer
i used a piece of square aluminum for the support and then ran 2 different sized coils through it. i havent decided yet if i am just going to connect the two at the bottom or if i am going to extend them and make it 2 completely separate coils giving each a cold water feed or just make it all one big coil.
ideas?
if i make it all one piece should i have the cold go to the inner coil first or the outer