anyone else have a slight bend in their installation of their sight glass?! In no way is this any problem with bobby_m's product more than likely and error on installation end here..
Wen above the suggest 5/8" center start for the hole and went with the a one inch.. still ended up with think bend.. its a half coupling thats surface welded to the keg (not a full coupling that is sagging) and even with the angle that the glass is installed to the reducing nut i have this 25-35 degree bend away from the keg that is held in buy eye bolt..
cause its welded i pretty much have to live with it and i was hoping that there were some other members that could give insight on a way to either reduce the curve or experience on how theirs works with the curve (assuming im not the ONLY person who has done this)
i have not calibrated it yet so i dont know how it is effected.. i wanted to see if any solutions would come of this post!
thanks in advance
Wen above the suggest 5/8" center start for the hole and went with the a one inch.. still ended up with think bend.. its a half coupling thats surface welded to the keg (not a full coupling that is sagging) and even with the angle that the glass is installed to the reducing nut i have this 25-35 degree bend away from the keg that is held in buy eye bolt..
cause its welded i pretty much have to live with it and i was hoping that there were some other members that could give insight on a way to either reduce the curve or experience on how theirs works with the curve (assuming im not the ONLY person who has done this)
i have not calibrated it yet so i dont know how it is effected.. i wanted to see if any solutions would come of this post!
thanks in advance