I made a dip tube for my bottling bucket out of a 90 degree PVC elbow (3/4 inch).
I used a hacksaw an took off around 1/4 of an inch, but I still have somewhat jagged edges.
How do I smooth them down?
What type of sand paper, or is there something else to use?
This may have been dumb, but I used concrete as sandpaper. Id did a good job of wearing down the bumps, but not there is dirt embedded in it. I am soaking it in Chlorine, but wonder if its no longer safe for bottling, as the dirt may contaminate the beer, even if it soaks for a week in Chlorine solution
Mods - if this is not the appropriate forum, please move it to where it should go.
I used a hacksaw an took off around 1/4 of an inch, but I still have somewhat jagged edges.
How do I smooth them down?
What type of sand paper, or is there something else to use?
This may have been dumb, but I used concrete as sandpaper. Id did a good job of wearing down the bumps, but not there is dirt embedded in it. I am soaking it in Chlorine, but wonder if its no longer safe for bottling, as the dirt may contaminate the beer, even if it soaks for a week in Chlorine solution
Mods - if this is not the appropriate forum, please move it to where it should go.