Toecutter
Well-Known Member
So I have been working on this brew rack for several months, little by little and were almost ready. My goal was to bring all my equipment together on a rolling cart that I could move around as necessary. I had been using a plastic rolling tool box with the pump mounted on, but it was would sometimes fall over from the weight and balance of the pump . my water filter and chiller were separate and I would bring them out as necessary. Now everything's integrated in one place, and I have room to put an orange cooler on top to run cleaner through everything at the end of brew day. I use a Hurricane NG burner mounted into the top of my backyard Bar/BBQ .
Now don't laugh at my welding. . A welder or craftsman I'm not, nor will pretend to be. I used a Harbor Freight 90 amp Flux welder,and some angle steel.
Thanks to Bargainfittings and Brewhardware for a lot of the fittings etc.
Now don't laugh at my welding. . A welder or craftsman I'm not, nor will pretend to be. I used a Harbor Freight 90 amp Flux welder,and some angle steel.
Thanks to Bargainfittings and Brewhardware for a lot of the fittings etc.
