Thank you for your efforts!
I have a dual chamber I am looking to control with a single Pi 3A+ using fuscus and fermentrack.
I have managed to get them up and communicating well for a single instance.
If I understand this correctly I can just start 2 separate instances of fuscus each with its own ini file?
Also, on the upper chamber I am using a 12V peltier device to do the heating and cooling. I use a SPDT relay to change the polarity for heating or cooling. I can see an easy way to implement that with fuscus though I wonder if you could point me where to look to add a control for the fans that are used to blow on the heat sinks on the peltier?
I would like them to have an off delay so they run for a few minutes after the peltier is powered down.
I have a fan in the lower chamber too. It uses the guts of an old viking fridge and a 140w heater.
Any advice or guidance here would be appreciated.
Cheers,
Jon
I have a dual chamber I am looking to control with a single Pi 3A+ using fuscus and fermentrack.
I have managed to get them up and communicating well for a single instance.
If I understand this correctly I can just start 2 separate instances of fuscus each with its own ini file?
Also, on the upper chamber I am using a 12V peltier device to do the heating and cooling. I use a SPDT relay to change the polarity for heating or cooling. I can see an easy way to implement that with fuscus though I wonder if you could point me where to look to add a control for the fans that are used to blow on the heat sinks on the peltier?
I would like them to have an off delay so they run for a few minutes after the peltier is powered down.
I have a fan in the lower chamber too. It uses the guts of an old viking fridge and a 140w heater.
Any advice or guidance here would be appreciated.
Cheers,
Jon