nolabrew85
Well-Known Member
I just realized that I kegged my last beer with the gas dip tube on the "out" side and the beer dip tube on the "in" side (so opposite of where they should be), but I have the keg posts on the right sides. It's a ball lock corny. It's carbonated, so I was afraid to remove the posts and tubes, resanitize, and then swap them, because I didn't want beer to foam up and over flow and I didn't want to lose so much carbonation and have to wait to recarb. For now, I swapped my gas disconnect to my beer line and beer disconnect to my gas line so I could fit them on posts and try to get some beer without opening the keg. However, the beer comes out VERY slow this way. I am guessing the gas disconnect just isn't meant to flow that way?? Anyway, any suggestions on the easiest and safest way to remedy this situation with ruining the beer are greatly appreciated. Thanks!!!