Inkbird help please

[Brewing1976]

I just received the inkbird. How do I set the temperature range for the heating side and cooling side? No instruction in the box. Thank you

 

[@RoyalGallon]

I just received the inkbird. How do I set the temperature range for the heating side and cooling side? No instruction in the box. Thank you

Here’s a link to the pdf version of the manual.

http://pmod79883.pic31.websiteonline.cn/upload/2016_6i82.pdf

 

[mongoose33]

Plug it in, then press the "SET" button for 5 seconds and it'll go into the settings mode. Keep pressing the set button until you get to the parameter you want, use the up and down arrows to set it, then press and hold the SET button again until the Inkbird goes back to the default phase.

Assuming it's an Inkbird 308 you have, page 6 on this document shows the settings:

https://images-na.ssl-images-amazon.com/images/I/81VNbdWYmbL.pdf

The one Royalgallon shows above is for the Inkbird 310.

 

[Brewing1976]

Here’s a link to the pdf version of the manual.

http://pmod79883.pic31.websiteonline.cn/upload/2016_6i82.pdf

I gather you have one

 

[AzOr]

The instructions are not helpful. I consulted my assistant (youtube). I have the 308 and watched a few vids that were very helpful.

 

[Brewing1976]

The instructions are not helpful. I consulted my assistant (youtube). I have the 308 and watched a few vids that were very helpful.

After reading them they sure aren’t helpful

 

[@RoyalGallon]

I gather you have one

Yep they’re really good and easy to use but I need to refer to the flow chart in the pdf to work out what to change and why.

As @mongoose33 says press and hold sett till the display flashes and use the arrow buttons to change each set point.