Punx Clever
Well-Known Member
- Joined
- Nov 27, 2007
- Messages
- 490
- Reaction score
- 558
Got busy and put together some washable, removable insulation for the HLT and MLT of my 3 vessel eHERMS. MLT is 100% done, and has edging on the cut edges now. HLT is 90% done, but the hard part is over, just needs grommets and edging.
Each one is 50" x 18" with cutouts for the fittings and grommets to tie it all together. They consist of a doubled-over moving blanket. A 72" x 80" moving blanket ($15 - https://www.amazon.com/gp/product/B01MTVGT4K/?tag=skimlinks_replacement-20 ) provided enough material for both with some leftover
I used the MLT one already and got better performance than the layer of reflectix that used to be on there, so I figured it would be worthwhile to put together one for the HLT too. Mash tun at 150F was cool to the touch during the mash. Should speed initial heat up and ramping significantly.
Not too shabby.
Each one is 50" x 18" with cutouts for the fittings and grommets to tie it all together. They consist of a doubled-over moving blanket. A 72" x 80" moving blanket ($15 - https://www.amazon.com/gp/product/B01MTVGT4K/?tag=skimlinks_replacement-20 ) provided enough material for both with some leftover
I used the MLT one already and got better performance than the layer of reflectix that used to be on there, so I figured it would be worthwhile to put together one for the HLT too. Mash tun at 150F was cool to the touch during the mash. Should speed initial heat up and ramping significantly.
Not too shabby.
Last edited by a moderator: