What no pictures of your garage brew space?Lets see your garage brew spaces.. I finally got rid of some junk and have room for a permanent brew space in my garage..
What no pictures of your garage brew space?
I moved my brew space into my basement since I store my equipment down there and I got tired of hauling the equipment up/down the stairs.
Normally the brew space is my basement kitchen, I slide the oven out and put my burner in place (both fueled by natural gas). The overhead vent fan vents to the outside. I also installed a CO and a gas detector as a precaution. On the other side of the wall, I have my fermentor inside an upright freezer that I can pump my wort directly into, thanks to a sleve I installed in the wall.
View attachment 764606View attachment 764607View attachment 764608
Now you need a Plumber/Pipe Fitter friend to hard pipe your beer lines.Anyhow, it's only about a 30' run from this location to my main panel. I'm going to run a 3/4" conduit up and install a couple 120 outlets along this wall and rather than the normal ebrew panels with cords and outlets, this will be hard piped and wires direct. I'm goin to have a 50a gfi down stairs at the panel, 6awg wire coming up (have to derate since I'll also have the wall outlet wires in the same pipe) and there will be a 50a breaker din rail mounted inside the panel along with the main contactor to act as my local disconnect. I'm not really a fan of all the plugs under the panel, so I'm going to have one 14/5 SO cord come down to a local jbox to power the pumps. RTDs will be wired as normal with the microphone cables, and the elements will be the only twist locks on the panel and will mount to the vessels via tri clamp.
I really like my 30Kbtu infrared natural gas garage heater.What are everyone's thoughts on the new condenser lids? Since I'm going to be running conduit up from the panel, I am also going to pull wire for a 10kw garage heater and it'd be really nice to finall be able to have the door closed on cold brew days..
Is that one of the wall mount designs? I don't really have the wall space down low for a unit without a fanI really like my 30Kbtu infrared natural gas garage heater.
I'll buy the tube, bring your tig welder on overNow you need a Plumber/Pipe Fitter friend to hard pipe your beer lines.
Interested in this too! We're enclosing the covered patio area I used to brew in to make it a more dedicated (and clean) brewing space, and I'm interested in seeing what other people are doing.
What are everyone's thoughts on the new condenser lids? Since I'm going to be running conduit up from the panel, I am also going to pull wire for a 10kw garage heater and it'd be really nice to finall be able to have the door closed on cold brew days..
This is incredible! Where did you get the metal pegboard? That would look sharp behind my brewing set up!Not a perfect picture, just what I had on the phone. The full front of the garage is bew space. Hard to see but the far side has kegerator and stainless utility sink. 3rd car garage has all of the ingredients and storage for stuff.View attachment 764656
...I got all the drywall up and should hopefully be finished sanding tomorrow. It really sucks moving everything around!
That is beautiful!Finally finished putting it all together. First brew in the space this weekend!
Finally finished putting it all together. First brew in the space this weekend!
Oh, I do need a Admiral sign! However, 5 of those containers have their malt inside!Good Job! Very nice and nicely organized... I like it.
Nice Faction sign... now you need something from Alameda Island or Admiral Maltings...
Enter your email address to join: