As stated above. The simple tool went in quite a bit crooked. The bottom of the dimple is about 1/4" out. And the top is barely beveled.
I ended up screwing up the threads trying to pull the coupling through anyway. So I'm going to have to order a new coupling.
I was thinking I could hammer the edge flat again. And the try to redimple the hole. Hopefully doing it somewhat straighter.
Anyone have any experience with these?
I ended up screwing up the threads trying to pull the coupling through anyway. So I'm going to have to order a new coupling.
I was thinking I could hammer the edge flat again. And the try to redimple the hole. Hopefully doing it somewhat straighter.
Anyone have any experience with these?