Recent content by Zinc_Saucier

In!

Might depend on the type of valve, but I broke down my Blichmann BK and HLT valves after many many batches, and both were sparkling clean. I flush with hot water after each brew and then PBW 1-2 times per year

Thanks! Used the below mount from Amazon. I have the panel from Kal, and when the silver mounting brackets (don't know the actual term) are removed I used the hardware they were attached with to attach the mount to the panel. Had to widen the holes in the mount a little with a drill, but...

Now we're cooking with... electricity

In! Thanks

Bump

4lbs of Yakima Valley hops (excited to try out the 007!)

Over the past three years moved from this To my e-HERMS

I've got a 20g Blichmann kettle and do 5g batches from time to time. (Well usually 6 gal ending volume, .5 for trub and such in the kettle, and .5 for the yeast post fermentation)

Bump

For sale used Greenlee punches and step-bit (plus 2 hole saws) 1ea 1-1/4" conduit punch (43.2mm) 1ea 1-1/4" punch (i think 31.7mm?) 1ea 1-1/4" punch (31.7mm) 1ea 1/2" conduit punch (22.5mm) 1ea 13/16" conduit punch (20.6mm) 1ea 9/16" punch (14.3mm) 1ea Greenlee step-bit (PN 36414) 1-3/8" 1ea...

This was my old setup. Ground fault for computer/mill/etc, and switched outlets for the pumps.

Going to give it a little bit more time before parting it out, but I'll let you know

Edit: sold

Like Govner1 I run the wort thorough my pump/cfc just after shutting off the flame on the boil, and let it recirculate for a few min until everything is nice and toasty. However I don't use StarSan on it, rather let the heat kill off any wild bugs, and then flush well with very hot water after...