Recent content by ugadawg311

What do you mean by this? Am I able to replace the lines?

Do you have a link to the Eva barrier line? My current lines are 3/16” inner diameter and pretty short - maybe 5 ft. I get lots of foam in my pours, mainly on the first 2 or 3 beers. I’ve read that I probably need longer lines to help with the foam.

Ok thanks for the link! And once I get the nut off, I’ll be able to remove the beer lines pretty easily? Then insert new lines? It kind of looked like the lines were sealed into that connection maybe at the factory, so I was afraid of permanently ruining the taps.

Is it possible to change the beer lines I have in my two-tap tower (see picture)? Normally I clean the lines, but I thought it might be a good time to replace them. Do I need to just loosen the golden nuts? I’d hate to ruin the tap, and I can’t tell if the lines are not meant to be removed. Any...

I'm looking for a 5/16" ID CO2 line with a connector to run from my CO2 splitter to my keg coupler. Fortunately, I have one already, but I need another for a second keg. Do these lines exist anymore? All I can seem to find are the 3/16" lines with the connector. None of the 5/16" lines I've...

Now I found out that both of my keg couplers don't have hose barbs for the CO2 line. I have one line with a hex nut on it, but I need another to connect the second keg. Is there any workaround here?

Now I need to find another 5/16" ID gas line to run from the CO2 splitter to my second keg (the line needs a hex nut as well to connect to the coupler). A line similar to the link below would be great, but I need a 5/16" ID line. Anyone know where I can find one...

Hmm didn't think of that. There a couple fire equipment places nearby that I could try. Thanks for the tip!

Thanks for all the information everyone! This has been super helpful. For now I went with a dual CO2 splitter and will just use one tank. In the future I'll likely get a 2 body regulator or just use both of the CO2 tanks I have. So now I've got the tank, the lines to run gas into the kegs...

Ok, thanks for the link. And 5/16 inch is the size I want right? (I assume that's the standard size.)

Thanks for the info. Can you please post a link to any tee, wye, or manifold that you'd recommend?

Yes, the current tank is in a cabinet next to the kegerator, and the second tank could easily go there too. I'm planning on having a bitter IPA and possibly something lighter - maybe a sour since my wife likes those, so I think I should be ok with the same pressure for both kegs. I haven't been...

I'm a noob here trying to set up my first home bar. The previous owner left a kegerator with a single tap installed into the bar. However, I'd like to use two 1/6 barrel kegs instead of one 1/2 barrel. I purchased a dual tap tower that should arrive soon, but my question is, what additional...