I use a double sided jumper to purge my transfer line with CO2. Then I ‘purge’ the line with beer from my fermenter, and discard a few ounces that might get a bit of O2 exposure. After that I connect to my keg and transfer, and hope it was enough.
I’m no woodworker so I probably did this wrong, but I used brad nails and glue to add oak to the outside of my pine collar. So far 2 years with no issues.
New replacement gaskets are in. Got mine in the mail today. They no longer have a flat side and a pointed side but now both sides have the same point. Will pressure test it tomorrow but went in just as easy as the old style. Tried my best to get a photo - new on left old on right.
I was able to load the alpha version via the web flasher and access the AP / configure the device.
Went out to the garage to connect to the tilt and it seems its battery died. Now I need to wait another week to retrieve my tilt from the fermenter.
I'm also experiencing the same issues as Franz and Stov.
D32 Pro with the Lolin TFT.
I've used both the web loader and the desktop 1.3. I get "Firmware successfully flashed. Unplug/replug or reset device to switch back to normal boot mode." The screen turns white but no text and I can't see...