Maybe wrong choice of words but I found ages ago the calculator to do this with kegs and 70/30
The plan is after the primary fermentation to fill the keg and then just put it in the cooler at 50f 10c for a week with 70/30 connected at 2bar / 30psi - will this give me a nice creamy beer or have...
So we are well versed in kegging our lager by purging keg first with co2 then filling with beer… if we do a couple of kegs they can last a good few months - in fact that’s as long as we’ve tested as it never hangs around past then…
We are going to have a go with a dark beer and 70/30 nitro/co2...
Hi guys - I’m on a drive to Lee my line lengths short as I’m wasting beer in them.
I currently have kegs with 4ft of 3/8 coming out going through a chiller which then goes into a 9ft 3/16 line to the tap… works perfectly…
The new plan was to have the 3/16line 3FT and and the 3/8 2ft...
Hi guys - I got the propane regulator as mentioned but I a lot of co2 comes through is very audible even in setting 1 is this right? I have got a Micromatic regulator that’s goes down down to 3psi and the new one is loader on 1 than that at 3psi by some margin - trying to work out if I have a...
Hi All - I have bought a few fonts now the Porta chrome style and they all have some degree of corrosion bubbling under the chrome or already burst through. is there anyway to fix this I assume not and its just cheap metal?
also another question on this do you guys run pure co2 (like me) what life does it give you in a cask? I get a good 4 weeks.. I’m thinking of swapping to 60/40 and wondered if I could expect similar?
When you say set to 3-7 is that psi?
We had gone with regs directly before set to about 5 and the flojet but got a bit more fobbing - I guess these Cleese regs offer more control can you get John guest fittings?
Another solution to my problem is would an angram hand pull work if I dropped the...
Hi guys - I currently have a couple of hand pulls and a co2 cask breather setup - it’s great and keeps the conditioning in for a good week or two.
The problem is the wastage is about a pint per pump when I pull the lines through.
I had an idea which I’ve not seen anyone mention on the internet...