Cincy17 said:Just finished this Saturday. It's the Kenmore Elite 4.9 cu ft like the Sanyo 4912. Got it used/like new for $60.
Really nice work. I'm guessing the draft tower is 3 or 4 inch PVC? I'm using the same PVC base as yours to attach both ends of my draft tower. I thought they looked familiar. What are those spacers you have on your faucets/shanks? I had 4 inch shanks but they wouldn't fit in my PVC so I cut them down to around 2 inches. Had I though of using spacers like that, I wouldn't have needed to cut the shanks. Good build
ajwillys said:I hate to speak for him, but they look like tower shanks:
http://www.micromatic.com/draft-keg-beer/taps-faucets-pid-4329A-3E.html
Really nice work. I'm guessing the draft tower is 3 or 4 inch PVC? I'm using the same PVC base as yours to attach both ends of my draft tower. I thought they looked familiar. What are those spacers you have on your faucets/shanks? I had 4 inch shanks but they wouldn't fit in my PVC so I cut them down to around 2 inches. Had I though of using spacers like that, I wouldn't have needed to cut the shanks. Good build
I hate to speak for him, but they look like tower shanks:
http://www.micromatic.com/draft-keg-beer/taps-faucets-pid-4329A-3E.html
I was hoping there was a thread like this on homebrewtalk.com! this is my kegerator I made out of an old fridge from my parents basement ... I have this one for my garage and am now looking for ideas for my next project for my basement bar... Not as nice as a lot of the ones on here but it's the perfect addition to my garage!
Canadianbrewer2012 said:Yeah well I really like the look of the single tap in front for this fridge so I am gonna have a couple cobra taps inside .. I want to make a nice red mahogany keezer with 4-5 taps for my next tho
unfinished, but it's serving cold/carbed beer!
Put up a chalkboard above the new kegerator!
I have that exact same fridge. Do you have a build thread somewhere or a wiring diagram?
I have that exact same fridge. Do you have a build thread somewhere or a wiring diagram?
Thanks! I used adjustable shelving to hook into the freezer collar.
So a lot like this, but i cut out the drip try template from the top nicer piece of wood so they wouldn't slide and so they could be easily removed and cleaned.
I also made sure to screw the two pieces of wood together, to prevent sliding.
I also need to check back at Home Depot to see if they have any black foam for the seal between the bottom of the wood and the base - the gray sticks out a bit too much.
[/IMG]
A clean bead of black silicone might give you want you're looking for.
rourky80 said:While not technically a kegerator, this is my version and what i'm using as my kegerator. A pre-mix soda machine, to dispense my brews..... "Fauxster's - Australian for homebrew!"
My thread.. https://www.homebrewtalk.com/f51/my-beer-dispensing-using-soda-machine-365291/
Genuine said:Here's mine all cleaned up as ready to go!
I'm debating if I want to plastidip the door satin black.
Enter your email address to join: