logdrum
Well-Known Member
OK, so this is just from a preliminary water test with my EZ Boil controller, but when I ran a recirculating trial (tap water in my Spike mash tun, to a chugger, through a RIMS Rocket, back to mash tun) the temp probe at the exit of the RIMS Rocket read 133ºF (my set point) but the water in the mash tun (measured with a Thermapen) was at 122.xºF. I am a total RIMS newby, so I'm curious if this behavior will carry over to a real life mash, or will the thermal mass of the grains alleviate the offset? Thanks in advance!