Can someone confirm what size tubing bender I need?
To control mine I just turn the burner on my stove down. By the end of the boil the stove was on low.Do you have it plugged straight into the wall? No pid or controller of any type?
I ended up with a boil off rate of about 0.8 gallons an hour. A little lower than the software predicted so I might have the stove on a bit next time. I am very happy with this product and wouldn't hesitate to recommend it to anyone.
If you want to bend it yourself, you'll need a 5/8" tube bender.
How hard was it to work that wire through the 90 deg bend?
10/3 SJOW with just the inner conductors, you'll have to use a stiff piece of wire to pull them through and you'll do better with some keg lube on the wire.
12/3 should be pretty easy with the outer jacket removed. Intact, you'll have to pull with a stiff wire as you feed it in.
Don't make the mistake of getting SO cable, it's thicker. SJOOW is what you need.
Bobby, what size is the TC clamp on the Hot Rod?
Enter your email address to join: