knuckleheadbrewing
Well-Known Member
I am running a RIMS system with a TDWK XMTA-8000 Temp controller (first pic.) The original temp probe with the system broke (the wire) and I replaced it with an Auber 4" probe (http://www.auberins.com/index.php?main_page=product_info&cPath=20_15&products_id=246) with the deluxe quick release cable. Problem being, my original temp probe was only a 2 wire, and my probe is a 3 wire probe, I wired it up according to the diagram on the controller but when I run it with 3 wires my reading shows 1231 degrees and jumps around. If i use only 2 wires the temp drops to 60's but I cannot get it any higher then 62 desgrees.
My question, Does any one know if a way to reset this controller or how to calibrate it for the new probe? The only manuals I can find online are Chinese which doesnt help me much.
Hoping some one can help....
My question, Does any one know if a way to reset this controller or how to calibrate it for the new probe? The only manuals I can find online are Chinese which doesnt help me much.
Hoping some one can help....