I recently built a kegerator from my old mini fridge, and I've been having issue where it seems to burp all foam for the first couple seconds of the poor and then seems fine. If I leave it for a minute or two and top up I generally see the same issue occur again.
Here is the kit I bought: 2 Faucet Tower Kegerator Conversion Kit - Stainless Steel Tower - US Sankey D System - No CO2 Tank (I only measured and realized after that I can only fit 1 30-L keg after I purchased, but the co2 is turned off for the second line)
I have also since bought a tower cooling thinking that may have been the issue, and, I also bought an inkbird to make sure the temperature is correct. I have it set to 34F now with a 1 degree variance and the probe is in a bottle of water.
I also realized there was no washer/gasket on the beer line to the coupler and thought maybe that was the issue. When I bought a cleaning kit one was provided so I cleaned the lines and installed it to the same results.
My co2 is set to about 8psi, and anytime I tried a higher amount there is even more foam.
Does anyone have any guidance or tips to prevent/fix this?
Video can be seen here: 2 new items by Kyle Benner
Here is the kit I bought: 2 Faucet Tower Kegerator Conversion Kit - Stainless Steel Tower - US Sankey D System - No CO2 Tank (I only measured and realized after that I can only fit 1 30-L keg after I purchased, but the co2 is turned off for the second line)
I have also since bought a tower cooling thinking that may have been the issue, and, I also bought an inkbird to make sure the temperature is correct. I have it set to 34F now with a 1 degree variance and the probe is in a bottle of water.
I also realized there was no washer/gasket on the beer line to the coupler and thought maybe that was the issue. When I bought a cleaning kit one was provided so I cleaned the lines and installed it to the same results.
My co2 is set to about 8psi, and anytime I tried a higher amount there is even more foam.
Does anyone have any guidance or tips to prevent/fix this?
Video can be seen here: 2 new items by Kyle Benner