HDIr0n
Well-Known Member
So we are buying a new house, and now the uncertainty begins. I now have a HERMS setup for electric/propane with an E-HLT using 110v and a propane BK. So a lot of the houses I have been looking at/ have a contract in have Natural Gas in the Garage. There are less that have 210v to the garage, which I know can be had for a nominal fee (about 2k in my area). Soo I have been leaning towards Natural Gas. Soo my question is for those that have a HERMS setup with a brutus gas setup. I am not going to have a direct fired MLT as now I have a rubber coated bottom drain keggle that I want to control the temp through the HERMS coil in the HLT controlled by the PID(Auber) and gas solenoid valves. So how do y'all setup the BK? I was thinking that I would have a pilot vlave, and a solenoid valve controlled by a switch for a constant on or off and a ball valve to control gas flow. Is only 1 PID needed? I would like to display the temps on my control panel of the Mash/HLT/BK. Oh and I plan on doing a weldless 1550 design minus the tippy dump, unless I can figure out a way to do that.
Thanks,
-G
Thanks,
-G