Finally got around to building 3 last night using the cherry Phillip 4.0 board. I Couldn’t get the battery conversion factor dialed in and that’s when I realized I used 220 ohm resistors instead of 220 kohm resistors guess I didn’t notice the k. Hopefully I didn’t do any damage. I ordered some 220 kohm from mason when they get delivered I’ll heat up the old ones and pop them off. How likely did I do any damage. They seemed fine just read a higher than actual battery voltage even with the max conversion factor set. I’ll just not turn them on again until I get the right part. View attachment 669483
If you didn't let any of the magic smoke out, you may still be good to go!