so i just spent $80 on a couple ball lock bulk heads, floating dip tube. couple bev out conectors for closed tranfers...not for o2, but saving co2, lol
i'm an anxious person, and want to know sooners then friday when the stuff shows up if this damn milk can lid will hold 10+ psi....but the hole i got drilled in it now only holds 2-3psi, because i can hear it hissing out where i cramed the tubing into it....i stuck a barbed fitting into the under side hoping it seal better when i pulled it up from the under side. no luck it just holds the said 2-3 psi.....i'm hoping the bulkheads with bolts and nuts and o-rings seal better...but eager to find out how much the lid can handle? any ideas? 5/8" OD tubing. 5/8" hole but it's kinda lose, and only holding a few psi?
i'm an anxious person, and want to know sooners then friday when the stuff shows up if this damn milk can lid will hold 10+ psi....but the hole i got drilled in it now only holds 2-3psi, because i can hear it hissing out where i cramed the tubing into it....i stuck a barbed fitting into the under side hoping it seal better when i pulled it up from the under side. no luck it just holds the said 2-3 psi.....i'm hoping the bulkheads with bolts and nuts and o-rings seal better...but eager to find out how much the lid can handle? any ideas? 5/8" OD tubing. 5/8" hole but it's kinda lose, and only holding a few psi?