I have a 2 keg set up that uses a single body regulator with a gas manifold with 2 valves. At some point I would like to add a 3rd keg. I'm hoping not to have to lay down 40 bucks for a new 3 valve manifold and was wondering if there was a way to modify this one. I notice like most of them, my manifold has the barbed nipple on one end where the gas in goes and then 2 switched valves on the bottom and a screw cap on the top (see pic below). My question is can I remove the screw cap and add a 3rd valve?
Thanks
Thanks