Starrider
Well-Known Member
I have been searching but can't find any discussion on my issue.
I have craftbeerpi 2.2 running on a very basic fermentation setup just to get it running. It is reading temp and turning the heater relay on/off as expected.
The problem is it won't advance to next step. A single step/target temp seems to work ok but when I set up additional steps, it plays stupid.
After I start the program and get the temp to the first step target, the countdown timer starts. When it gets to zero, it just stops. The timer shows all zeros but no end time and it doesn't start the next step.
Any ideas what's going on?
I have craftbeerpi 2.2 running on a very basic fermentation setup just to get it running. It is reading temp and turning the heater relay on/off as expected.
The problem is it won't advance to next step. A single step/target temp seems to work ok but when I set up additional steps, it plays stupid.
After I start the program and get the temp to the first step target, the countdown timer starts. When it gets to zero, it just stops. The timer shows all zeros but no end time and it doesn't start the next step.
Any ideas what's going on?