Brian Dempsey
Member
- Joined
- Nov 12, 2018
- Messages
- 12
- Reaction score
- 0
I am in the process of building my first all electric setup. It will be a 15/16G kettle with a ball value, temp prob, and heating element. I am most likely going the 240 route, with one of these 3 options:
https://www.brewhardware.com/product_p/elementkit_tcrip_wl.htm
http://www.theelectricbrewery.com/Camco-02963-5500W-240VAC-ultra-low-watt-density-ULWD-RIPP-element
https://www.amazon.com/dp/B000BPG4LI/?tag=skimlinks_replacement-20
Each one has pros and cons, but i was looking not to spend 130 or 140 on something. The element itself would be a DIY type effort and cost a lot less. Any opinions are welcome, looking to see who has used the above and thoughts on them. Also, how did everyone make he hole in the kettle (a hole saw or punch).
Gimp
https://www.brewhardware.com/product_p/elementkit_tcrip_wl.htm
http://www.theelectricbrewery.com/Camco-02963-5500W-240VAC-ultra-low-watt-density-ULWD-RIPP-element
https://www.amazon.com/dp/B000BPG4LI/?tag=skimlinks_replacement-20
Each one has pros and cons, but i was looking not to spend 130 or 140 on something. The element itself would be a DIY type effort and cost a lot less. Any opinions are welcome, looking to see who has used the above and thoughts on them. Also, how did everyone make he hole in the kettle (a hole saw or punch).
Gimp