Martin, Just curious on how the sulfate content is reported. The Wards report I received lists Sulfate (SO4-S). Would the multiply factor be required for correction in this case? See below; BTW in your opinion hows my water look? I just started getting into salt adjustments with using the software.
Results For :
Sample ID : SAMPLE NO 1
Location :
JOHN
pH 7.6
Total Dissolved Solids (TDS) Est, ppm 195
Electrical Conductivity, mmho/cm 0.32
Cations / Anions, me/L 3.2 / 3.1
ppm
Sodium, Na 70
Potassium, K < 1
Calcium, Ca 3
Magnesium, Mg < 1
Total Hardness, CaCO3 8
Nitrate, NO3-N 0.1 (SAFE)
Sulfate, SO4-S 8
Chloride, Cl 49
Carbonate, CO3 < 1.0
Bicarbonate, HCO3 73
Total Alkalinity, CaCO3 60
Total Phosphorus, P 0.02
Total Iron, Fe 0.01
"<" - Not Detected / Below Detection Limit