I have one. It is not bad at all.
Positives - all the bends, cuts, and welds are clean or otherwise well done.
Negatives - a few small sharp edges or burrs on a couple of the areas (minor). Not as highly detailed or fancy as some drip trays I have seen that are stamped, formed, or otherwise shaped. That leaves things a bit flat/plain/industrial looking if you will. I did not really care for the drain hose setup and the way it just sticks out the bottom. I just capped it off and clean it out every once in a while.
Also it is not as highly polished as many drip trays available so it has a bit of a brushed stainless finish. That could be good or bad depending on what you are going for.