Recent content by jcalisi

Yep!

Not yet but it tastes good. I'll carb and see how it goes.

I had a porter in fermentation and went to transfer to keg and this is what I found. I used sal-04 and kept it at 67 degrees. It smells and tastes good but don't want to make anyone sick.... i should note it's been fermenting for a month which isn't normal for me. It's been busy. What do you...

I tried searching for a while but came up blank as well. However, I did connect it just to see and I think you are right it's actually under the coil and gets really hot fast. Without moving air I don't think it would do much. I think I will just use my small space heater for now. However, I...

So my old chest freezer I was using as a fermenter gave up the ghost.. so I now am using an upright freezer. I have it wired and ready to go but wanted to see if anyone has tried using the defrost heating element for heat. I don't know what the duty cycle are on those but if I could I would...

Yes I will be putting it on the breadboard first but I need to order the caps and resistors for it. I found two different diagrams the one you shared and another. One used all caps and the other had a resistor and cap like a normal low pass filter would. Thanks so for each sensor they...

I'm trying to clean up my panel and everything associated. I need a set of knowledgeable eyes to make sure this will work. I'm putting my pressure sensors on one board and have them sharing vcc and ground. Also, I want to add the recommended vcc and data filters. My question is can I do...

is your owserver listening on 8080? Unless you changed that it should be 4304.

Ok. I'm an idiot.... I thought when it said defaults to that if I hit enter that is what it would use. I have it working now. Thanks Doug.

Ok I have the ds2450 up and running. Now when I run ./launch.sh it see the non-temp (mpx5010) and ask if it wants me to setup owfs. Beleow is what I get. I can go to ip:2121 and see the ds2450 and my two dallas temp sensors. I'm sure I've done something stupid but can find it. Detected...

I finally have a little time to work on this now. I have the bbb up and running with ubuntu and the app is up. I'm now trying to figure out how to wire this 1 wire A/D converter. The disc that came with it is broke and unreadable not to mention nothing on the Chinese site... I'm hoping...

how are you interfacing the mpx5010d for vol? Im using BBB and didn't know if i can use an open gpio or if i needed something to go between them.

sorry I think I may be missing something but should I be using pin 42 on the P9 header with BBB? I can't get it so see my temp probe at all. I tried one I had left over from a project and then pulled one from my working BT. It doesn't see either of them.