Recent content by docon86

Thanks for the quick response. I actually have RO that I hooked up to the kitchen sink already for our drinking water. Stoped brewing couple years ago since I really didn't have much time after the kids where born (twins) but now i started brewing again and that's when I finally decided to get...

So I just got my water report back. Bicarbonate seems extremely high.. is there anything I can do to lower it? Or should I just buy RO water in jugs. Thank you in advance

adjusted to .045 factory setting .039 i was using it tighter at about .036 and my efficiency was about 82% but i read and heard on "the Sunday session" that we (home brewers) should hit for 70-75% per john palmer because you get a better taste. well anyways i wouldn't mind trying out...

I am getting some grain under the false bottom but its mainly powder, but then the other filter stops that from getting sucked in...well at least most of it.. I'm going to adjust my gap to .045 see if that helps I'll report back after next brew thanx for the replies..

i actually just got done brewing right now as i type i will try to get some old grain and mill it just so u can see the grained milled thanks for the quick reply

so i finally got my herms electric brewery set up and running. i done about 4 batches with it but every time i get a semi stuck mash, it starts fine for about five minutes then the stream starts to slow down. it really never does completely stop but i find it harder to maintain the temp. i have...

i would be happy if i can get 10 gallons into fermenters

whats the process with a 15 gallon hlt isn't that the main issue when trying to do 10 gallon batches with the keggles? do you stop recirculating when you get your mash ready then add water to hlt, take it up to correct temp then start recirculating again?

What is the best way to brew 10 gallons with kals clone using keggles? I know he said you need 20 gallon kettles but was wondering if there Is a way to do it with my current setup. Thanks in advance

I hear ya. thanx for the response.

looking to try your recipe, sounds good..how long did you you mash and what temp? thanks

plus one on a all grain

Looking for empty kegs

thanks for the quick reply. im pretty sure the way you mentioned is the way i have it connected. thank you

i installed my 30a gfci breaker in my cutler hammer ch panel eveything is wired and i tested power at the plug and i get my 240v on the hot side 120 on hot to neutral or ground just want to have one of you guys just double check my work please