I have noticed that BS2 says to top up with water at certain points. I have never done this and usually just go with what I have. Do you guys top it up or leave it and if you leave it, is there a way to tell BS2 not to top up with water and maybe allow you to change the values to match measured? I looked for a different setting but I did not see one. I have all settings that I have seen dealing with topping up set to say that I do not top up so I am a little confused as to why it tells me to top up yet...
I am new to brewing with BS2... I have used it create recipes but have never used it per say while brewing. I am planning on using it now for measured values while brewing to keep track of my recipes and numbers. It looks like the little column on the bottom right of the design page is a handy place to make the values easily accessible to enter the measured info. Is this what this area is used for?
I am new to brewing with BS2... I have used it create recipes but have never used it per say while brewing. I am planning on using it now for measured values while brewing to keep track of my recipes and numbers. It looks like the little column on the bottom right of the design page is a handy place to make the values easily accessible to enter the measured info. Is this what this area is used for?