So there have been a lot of these threads so I'll keep it short and post pics. I'll also post the cut list in case anyone wants to copy this. I had Alro, the metal supplier cut everything to length, it was cheap and saved me a ton of time. The tubing is 1-15/16 not sure about the gauge, 16 I think. The bill at Alro was just over $100 but the guy gave me a good deal.
2x 60"
2x 40"
2x 20"
2x 8-3/4
4x 30-3/4
9x 12-1/2 (for the width, and I got too many)
As of now the sides are welded and the cross pieces are tacked in place. The 12-1/2 width is a little too wide for the kegs to sit comfortably. I think I am going to get some 1 inch tubing and put them about 11-14" apart for each keg to sit more stable. So comments and suggestions are welcome.
2x 60"
2x 40"
2x 20"
2x 8-3/4
4x 30-3/4
9x 12-1/2 (for the width, and I got too many)
As of now the sides are welded and the cross pieces are tacked in place. The 12-1/2 width is a little too wide for the kegs to sit comfortably. I think I am going to get some 1 inch tubing and put them about 11-14" apart for each keg to sit more stable. So comments and suggestions are welcome.