Counter pressure filler

[leandrocosta]

I'd like to build a counter pressure filter based on the BYO's 2005 project, and since this is a very old project I'd like to know if there is a modern, better project available.

These are the components I'm planning to use:

1/4” stainless steel tees (2): https://goo.gl/yC2Nig
1/4” stainless steel ball valves (2): https://goo.gl/mtLaUt
1/4” stainless steel needle valve (1): https://goo.gl/97MK2U
1/4” threaded – 1/4” compression fitting (2): https://goo.gl/TVzWtB
1/4” threaded – 3/8” compression fitting (1): https://goo.gl/MKMCsK
1/4” - 8mm barbed fittings (2): https://goo.gl/68jGdr
1/4” stainless steel tubing (16 inches)
3/8” stainless steel tubing (6 inches)

This is how I'm planning to use them: https://goo.gl/biqL6v

 

[baer19d]

Honestly, by the time to buy all the parts you could almost buy a Blichman beer gun.

 

[leandrocosta]

I'm from Brazil.

 

[baer19d]

Well that does make a difference 8 suppose. I honestly think a filler that requires two hands will be a pain to use. Other than that I don't have any advice about a better DIY option.