This is a great build Ron, I am thinking of modeling my stand design on yours mainly because I like how the burners are in there and the support. Any more pics?
Wasn't that damned expensive??No problem.
I started with 12 inch tube, cut about 2 inches out and squeezed it together with big hose clamps. Then welded back together. Ending up with the correct inside diameter. I don't recall exact size seems like 11 1/4 inch. I can measure tomorrow AM if needed.
how did you make the burner wind shield/mounts? did you buy steel tube that size or did you roll it and weld it? what the inside diameter of those also?
sorry for all the questions
Enter your email address to join: