Search results

The hose you linked is for the one lb bottle.

Problem is the reg is crimped to the hose.

So one side of the hose goes on the bottle and the other end attaches to the reg hose that came with the burner?

Amazon search found nothing.

Has anyone found a way to extend the hose length of a bayou classic SQ14 regulator hose. I just built myself a gravity brewstand and need to find a way to extend the hose so it can be connected to the tank on the ground. Dan:mug:

Thanks. Dan

I have a dual gauge dual regulator that I want to rebuild. I have the bell off but how do you remove the pin assembly. Dan

Cool wait long enough and your questions get answered. Dan

I gutted a small dorm fridge but built the compressor into this and it works fine. https://www.homebrewtalk.com/f51/not-another-fermentation-chamber-project-274494/

With the angel of the drain hole in my cooler the lowest point of the ball valve is about the same level as the bottom of the cooler. If I attach a hose barb with a hose I should be able to get almost everything out of the tun. The slots I cut on the bottom of the manifold go up about 1/3. It...

The drain for this cooler is on the back side. I put the round 1/2 rubber washer over the nipple, then the zinc washer, then the ball valve. Sorry I dont have a pic of the ball valve. Ill take one tonight and post it. Dan

The first thing I did was measure the bottom area of the cooler so I could design my manifold. Next I cut all the pieces and laid them out on the floor. Then I test fitted it all together I removed the drain valve from the cooler but left in the white rubber seal. Installed the nipple in...

So after building my fermentation chamber I decided to make me a Mash Tun so I can go all grain. The parts: I got this cooler from Walmart for $29 1/2" Ball valve from HD $7.32 9 copper 1/2 Tee's .99c each 1/2" copper elbow $1.29 4 copper caps .67c each 5 feet of 1/2 copper...

Thanks for the info. Dan

I need the CO2 valve for a RS-D spear. Does anyone know where I can get one. Brewman

Bump.

I am trying to find some replacement parts for my spear. The CO2 valve is shot and I need to replace it. Where is the best place to find replacement parts for the spear. Brewman

Yes, take out the old thermostat and wire in the STC-1000. One wire straight to the compressor and one goes through the cold relay on the STC-1000. Dan

The next step will be the finishing, sanding, staining and adding the trim. I will wait a few weeks to make sure everything is working right then ill do the finishing. Dan

ITS ALIVE And she is doing well. Yesterday I finished the seal, added the door locks and insulated the doors. Now the doors only have one layer of insulation right now but I can add the other two layers at any time. Ill probably do that today while brewing. As you can see in the pic's I...