Search results

Drilled a 15/16" hole in a 3L soda bottle cap. I drilled out a 5.5 stopper to accept two 5/32" beverage lines - gas in, beer out. Two adapters to connect the 5/32" to my regulator and picnic tap and there you have it. I'm planning to discretely run the gas line into the fridge and stash the...

I tried to make a DIY carbonator cap. I used the push in rubber car tire valve stems. They stink. I soaked them in star san to try to remove the odor with no success. I was thinking about using these little guys instead...any thoughts? (Also McMaster part no.7757K43) My thoughts were to drill...

Those are my options. Which should I go with? Going for most authentic bock result (with ale yeast anyway). Cheers

I've brewed quite a few of these now - future SWIMBO and her father are strictly gluten free. The common theme I've seen with the sorghum extract beers - the beer is dry and the CO2 bubbles are HUGE. Its basically like club soda which I think it makes it hard to enjoy. Any way to add some GF...

I'm building a heat exchanger that will be immersed in my carboy for the entire fermentation (temp controller). I've made some prototypes out of Copper and Aluminum.... I know we all use copper short term for cooling and many of us use Aluminum brewpots, but will either Cu or Al in constant...

Any thoughts on this? Similar to SOFC in that it uses ice for cooling. I'm working on this for an engineering school project. This is our crude, stripped down prototype so far. (forgive the poor insulation) Pumps ice-cooled water through the coiled aluminum heat exchanger. Extended...

I've never brewed a lager before. I've always been limited on equipment. Recently a few fellow students (ME students from Georgia Tech) and myself decided to develop a home brew temperature regulation system (without a refrigerator) for those who want the ability to precisely control...