Search results

Got a small project that you need to get finished? Need a port on a kettle, tun or fermenter? Weld repaired? Aluminum, Stainless, Steel. Sanitary welding is a specialty. I am looking to trade some welding or fabrcation for an O2 system, a pump, or a big propane burner. I'm in the York area.

I can't find pictures of the conical on the website. What brand is it? Material?

If I can make the assumption that this is preboil or on the boil kettle, then the weld process is less consequential then if it were on the cold side of the brew house. Yes, there is a proper, proven way to do things. But as with all things except space travel and nuclear or biological...

100% argon and 308 or 304 or 316 for filler. 0.023. or 0.030. or 0.035 diameter ekectrode for these thicknesses. Using a CO2 mix gas in concentrations over 10% will have a negative effect on the metallurgy of the weld and adjacent area. Usually elevated hardness and high probability of...

Would you consider having something built? Where in SEPA? Near Philly?

You could try hitting the weakest looking joint with a 5lb hammer. If it cracks, the welds are suspect. If not, you have a reason to gain confidence in your work.

I'm in York. What do you need welded on the keggle?

I'm not interested in the tv, but I can help you out with the welding of that keggle.

Ok. Now I'm hoping I'm not the I only one who shows up to help.

I'm in to help. Same address I sent the check to?

Please put me down for (1) BD-MOPA (1) CM-SPIL (1) CM-2ROW

If those ferrule-to-tube welds can ship in a box to PA, then I can weld them for you. Flat rate boxes are a wonderful thing.

Need any welding done? An extra port in a kettle or fermenter? A keg converted to a kettle? I can trade labor. I'll be delivering a brewstand within the next two weeks to Philly and can arrange pickup.

I maybe able to help out. I've built a brew stand or two. I'm in York.

I've used one of these units with success. I extended the probe so that the unit could be outside of the controlled environment to make changes, if needed. I made a jumper with spade connectors. Ohm checking will tell you if its too long. I upgraded to an STC-1000 to gain both heat & cool...

My keg mash tun drops a few degrees over a 60 minute mash. I just did a 23# grain bill and it held temps with a re-circ about halfway through. Another bit of advice, preheat with over temp strike water then add half the grain. Wait for the grain to absorb some water and then add the rest of...

Please pm your address to me and I'll swing by and pick them up.

I'll take both. Where can I pick them up?

It's a small world afterall. It's a small, small, world.

I can help you out. I live in York, but get down to the Philly burbs pretty regularly. I've done a lot of work for homebrewers and some pro brewers in the area. Your kettles can be saved. Send me a pm with an email and we can exchange info.