Search results

The door panel super easy. Just be careful not to tear the rubber door seal and you'll be fine. My only issue with the door was the clear acrylic sheet I used. it's really brittle, so make sure you pre-drill the holes for the screws. Using the removed door panel to line up the holes works well.

It went well, though I should have test-driven my work. Turns out I forgot to put back the plastic top before measuring the length of the screws I needed. I'll have to go back to the store to get longer screws. That being said, I couldn't find 1" copper pipes at my local hardware store, so I...

Hi everyone! So I'm about to start the irreversible part of the build and I would just like to confirm something. I've got the DAR125SLDD and after the cornstarch test, it would seem like there's no refrigerant lines running along the top except in the front edge of the fridge... Me being the...

Roughly about 5-10F off, so I'm assuming that peltier powered should be sufficient, but I have seen a lot of setup that aren't completed or were abandoned due to inefficiency

I was wondering if you managed to resolve your issue with keeping the temperature low. Apparently my `cold-room` is not as cold in the summer and I need to make myself something similar in order to keep brewing...

Thanks for the tip :) Now, I need to figure out a valid reason to head out to Joliette other than beer... My wife would probably not agree if it's "just" beer

Hey everyone! I'm a short time lurker and recently joined! I've already taken a few tips here and honestly, this is the best website find in a long while for me. I'm not an experienced brewer (I've got a total of 2 batches of brew made up to now, both of them all-grain) and my very first...

Just finished building mine based on the last design. Works beautifully! Happy to have seen this as I started cleaning my first brew's first fermenter! It just goes to show that the experience of others can be beneficial :D