Recent content by Wookey Jack

I installed the plumbing for my fermenter shelf. With it, I will be able to fill two fermenters with hot or cold water and drain them out into the floor drain. I will also be able to fill the mop bucket if needed. It is not hooked up to water yet, it will get done when I have the plumbing to...

I finally got my brewing area cleaned up well enough to take some pictures. Over the years I have installed an exhaust fan in the ceiling, an RO system under the sink and a lab faucet in the sink. I was able to find a Plano tool box that perfectly fit in the shelves. I also installed 2...

Man, it's been a while since I have posted an update... The knee wall for the bar is in and I epoxied the joints in the equipment/fermentation room and put down some garage floor paint.

Now for some pictures of the current progress: We dug out the floor below where the fermenters will go and put in a floor drain. This allowed is to locate where the main train pipe went from here so we were able to dig another hole for a floor drain for the sink. Once the concrete was back...

So I thought it was about time that I actually get some content posted in here. So this is kind of what the rough plan is for the bar, don't pay attention to the back of the bar as I don't have that laid out in Sketchup yet. There is a utility room in the works on the other side of the wall...

I am in the process of finishing off the basement in our house that we built about 5 years ago. When I was in the planning stages of the house, the thought was that I would either get some sort of 3 kettle setup or something similar. I had a gas line and a 220V outlet put in. I have since...